Hamilton Cams Flat Tappet Conversion Kit for 2019+ Ram 6.7L Cummins

The flat tappet conversion kit for the 2019+ 6.7L Cummins. The late 6.7 valvetrain isn't built for big power, this kit converts it to a proven flat-tappet setup with the steel cam, rockers, pushrods, and tappets to back a serious build.

• 178/208 steel camshaft
• Upgraded rockers with DLC-coated trunnions
• 10.5mm pushrods
• DLC-coated steel tappets

Fits: 2019+ Ram 6.7L Cummins.

Break-In & Install

Install: Flat-tappet conversion for the 2019+ 6.7L, follow the kit instructions. Flat-tappet break-in below applies.

We always recommend new lifters when changing a cam. Follow this break-in to protect the lobes:

• Apply a liberal amount of quality assembly lube to the camshaft.
• Do not let the engine start without oil pressure, we suggest not changing the engine oil until after the engine has been started.
• On a new engine, pack assembly lube into the oil pump and prime the oil filter so the cam gets oil fast.
• Disconnect the fuel system and crank with the starter until you read oil pressure or see oil at the rocker arms. Don't run the starter more than 10 seconds at a time.
• Once oil pressure is verified, start the engine and run it at 1,200-1,500 RPM for five minutes, then shut down.
• On a new engine, retorque the head (expect .003"-.004" more gasket crush, which changes valve lash, readjust the valves). Then you're cleared to use it.

At Full Send Diesel, we don't just sell parts. We stand behind them. Hamilton Cams machines their Cummins camshafts, valvetrain, and hard parts right here in the USA, and their commitment to performance and reliability lines up with how we build trucks.

We don't just carry Hamilton as a brand. We run their parts in our personal trucks, our in-house builds, and every giveaway truck we put together. If it's not good enough for our own trucks, it's not good enough for our customers. Hamilton Cams has earned our trust, on the street and on the dyno.